News For This Month:
Your water heater is among those home appliances, that you did not realize until it stops functioning. Your house’s water heater operates round-the-clock, and you can use it anytime you feel like. The sad part is the water heaters are often abandoned. We usually do not remember to see how the heater is fairing on. This can lead to a lot of issues and among them is no hot water. Your home is probably fitted with either the electric or gas-operated residential water heaters. It would be best if you understand how the heaters operate and what could be the cause of the water heater faults. The good thing is that the electric tank-type repairs are simple; usually, it is a fundamental that’s causing all the issue. However, if there is an issue with the whole tank, you might need to replace it entirely. Continue reading this article to discover the likely causes of water heater problems.
A malfunctioning heating system. This is a widespread problem in water heaters which are older than 10 to 15 years. If you abandon annual maintenance of your water heater such as flushing it out, it can bring about heating system problems. Some malfunctioning areas in the system entail, thermal switch, thermostat, and heating element. On the other hand, if you are using a gas-powered heating tanks, it could be that you are out of gas. If you have any of these tank problems, it will be best if you hire the services of a licensed plumber.
It could be that the dip tube is faulty. The purpose of the dip tube is to supply cold water into the heat tanks. If a dip tube works accurately; it pushes cold water down the tank so that it gets heated. However, if your dip tube is defective, it will only deliver water to the upper part of the tank. Therefore, the cold water could be coming out into the hot water outlet before it gets heated.
It could be that the deposits have piled up. Another popular cause of warm or cold water from heat tank is the build-up of propane cost per gallon deposits. Small amounts of dirt and minerals carried by the water that enters into your heat tank. The minerals and debris sink at the bottom of the tank and can accumulate with time. The element which heats the water is usually located at the bottom of the tank. So, when the dirt accumulates, it can hinder the efficiency of propane cost per gallon heating the water.
It could be the corrosion of the anode rod. It might be that the anode rod or the tank is corroding if the hot water coming from your tank is red or rust color. If this issue is not attended to immediately, it could lead to severe tank erosion, tank leaks or burst tank. Replacing the anode rod is straight forward and can increase the lifespan of your tank.